COMPANY HEADER
Request Information
When using HepcoMotion internal single edge ring slides it is recommended that two concentric bearings should be placed 120º apart in order to provide a datum reference. The other bearings should be eccentric type. All eccentrics can be used where positional adjustment of the ring is required. Either ring or bearings may be the moving element. The HepcoMotion PRT2 eccentric bearings are of double eccentric design with sufficient throw to enable disengagement of the ring, without further disassembly. One or more lubricators may be fitted at convenient positions to take advantage of the increased load/life afforded by lubrication
Unit of Measure

Specifications

For use with bearing

 N/A J25

Dimension A

 N/A 165 mm

Dimension I

 N/A 40.2 mm

Dimension J

 N/A 2.4 mm

Dimension K

 N/A 9.8 mm

Dimension L

 N/A 19 mm

Dimension M (Max)

 N/A 13 mm

Dimension M (Min)

 N/A 2.2 mm

Dimension P

 N/A 19 mm

Dimension Q

 N/A 12.25 mm

Dimension R

 N/A 10 mm

Drilling Positions

Dimension B

 N/A 23.0 mm

Dimension C

 N/A 24.9 mm

Dimension D

 N/A 1.9 mm

Dimension F

 N/A 22.5 mm

Dimension G

 N/A 16 mm

Dimension H

 N/A 18 mm

Manufacturing Notes

N/A

  • For Dimension K and L : Short or long stud lengths are available for each size of bearing 34-35. Choose according to the required mounting plate thickness.
  • For 2 : Exact theoretical values have been given for `B`, `C` and `D`. Positional accuracy of dimension `B` will determine the axis of the ring. Positional accuracy for dimensions `C` and `D` are not normally critical. Holes for bearing studs should be reamed to tolerance F6 for a sliding fit.
  • For Drilling Position : The eccentric blind hole fixing bearing cannot be used with the RIS 182 ring slide as it clashes with the ring.